Commonwealth INGENICO 5110 User Manual download pdf (Page 37)

PC-EFTPOS-CBA i5100 / i3070 Guide Page 37 15/12/2008

10.4 Argent Error Codes

Argent Basics

The seven segment display on the Argent Terminal Adaptor will light up and will move

through a sequence of numbers on start-up. The numbers displayed will be steady when

the call is progressing and the configuration downloading normally on the D-channel during

start-up. The display will flash continuously if call progress encounters an error condition

during start-up.

The table below provides a list of “start-up status codes” that the ATA will display in order of

sequence when the power is being applied, the call is being set up and the configuration is being

downloaded by the Argent Network Management System (NMS).

Argent Error Codes

Display Interpretation

Building Bars..........Program decompressing into memory

Steady 1 .................Power-on test executing. Dot will pulse on/off

Steady 2 ................D-channel interface active for EFTPOS

Steady 3 ................Pre-configuration in progress, learning identity

Steady 4.................Remote management in progress, configuration

Steady 5 ................Software download in progress

Steady 6 ................Reserved

Steady 7 ................Reserved

Steady 8 ................Reserved

Steady 9 ................Reserved

Steady 0 ................Reserved

Steady dot..............Normal Operation (no fault)

ATA Seven Segment Display Start-up Status Codes

Display Interpretation

Flashing 1...............Power up test fails

Flashing 2...............ISDN connection down

Flashing 3..............No carrier on EFTPOS port

Flashing 4..............Data overrun/underrun on Serial V.24 port

Flashing 5 .............No stations responding to polls on EFTPOS port

Flashing 6 .............Last call attempt failed, D-Channel

(X.25 fault or Argent server or NMS unavailable)

Flashing 7 .............Not applicable

Flashing 8 .............NMS has no pre-configuration to download

Flashing 9 .............NMS main configuration failure

Flashing 0 .............Not applicable

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 46 47

No comments

Commonwealth INGENICO 5110 User Manual Page 37